Hexagon tile floor – Firstly you must doing is ’tile setting’. For this, starting with weep all dirt and dust from floor. Mix thinset in 5-gallon bucket (pr. Mixing instructions on the thinset packaging). Apply thinset to the floor using mastic trowel. Apply thinset in small areas that are only slightly larger than a hexagon tile sheets. Starting work in the corner farthest from the exit room. Trim the wall edges of the hexagon tile sheet by nipping tile.
Set the hexagon tile floor sheets on the thinset and press firmly to ensure a good bond. Press the 2-foot level of tile face sheet surface to push out any uneven lumps. Work your way across the rest of the floor by means of this process. Trimming tile sheet by nipping and tile razor knife adjusted as required. Tile sheets are glued to the mesh fabric that can be cut with a razor knife. Allow the thinset to properly cure before proceeding to the next step. Refer to thinset packaging for curing times.
12 Photos Gallery of: To Install Hexagon Tile Floor
And then for hexagon tile floor grout, starting with mix the grout in 5-gallon bucket (pr. Mixing instructions on the grout packaging). Apply the grout to the hexagon tiles sheet using the rubber float and evenly tile the surface to fill all tile joints. Start the grout in the same corner you started laying tile. Clean the excess grout from the tile and joints using a large wet sponge. Rinse the sponge as necessary. Refer to grout packaging for any special or additional instructions.